Our categories
Our top brands
VISIOMED
Digital Thermometer
Soft Tip
Medical Device
Children
TheVISIOMED digital thermometer specially designed for children allows a fast and accurate temperature reading (10s).
By mouth, rectal or axillary.
The composition may be subject to variations, so we advise you to always check the list on the purchased product.
Thermosoft VM-DS200
Power supply: 1x SR41 (LR41) included
WARNINGS AND SAFETY PRECAUTIONS
- Keep the thermometer out of the reach of children to prevent them from playing with this product, swallowing or eating it.
- Do not bump the thermometer or let it fall.
- This product is 100% waterproof; however, it is not recommended to immerse in water or any other liquid.
- Do not expose the thermometer to direct sunlight, high temperature or humidity, or extreme environmental conditions: this may affect its proper functioning.
- Stop using the thermometer in case of malfunction or malfunction.
- Do not open the thermometer housing except to replace the batteries.
- Do not put the thermometer in contact with sick, ulcerated or bruised skin.
- Rising temperature in the rectum can cause internal injuries. In general, bleeding in the rectum, hemorrhoids and recent surgical operations in the lower bowel increase the risk of injury.
- Make sure the baby or patient has not taken a bath or has been swollen (for babies) in the last 20 minutes. This could produce an inaccurate result.
- Do not drink hot or cold drinks, and do not exercise intensively while taking the temperature.
- This ELECTRICAL MEDICAL DEVICE requires special precautions regarding electromagnetic compatibility. It must be installed and put into service according to the electromagnetic information provided in the EMC DATA table.
- Portable or mobile radio devices may affect ELECTRICAL MEDICAL DEVICES.
- Use only the recommended batteries; do not throw them in the fire.
- The measurement results of this product are for reference only. If in doubt, please contact your doctor.
- Do not modify this device without authorization from the manufacturer.
- Do not store or use this device outside the prescribed environmental conditions; otherwise, it may not work properly and its performance may be affected.
- Stop using the thermometer if the LCD displays "E". This indicates that the sensor circuit has detected an error (such as a circuit break or short circuit).
- The default alarm temperature is 37.5 ° C (99.5 ° F); the audible alarm then sounds "Di Di Di Di ...".
- The measuring range of this thermometer ranges from 32 to 44 ° C (89.6 to 111.2 ° F). If the test temperature is below 32 ° C (89.6 ° F), the LCD displays "L". If the test temperature is above 44 ° C (111.2 ° F), the LCD displays "H"; the alarm sounds. INSTRUCTIONS BEFORE USE Clean the tip of the rectal thermometer with soapy water or 70 degree alcohol. For hygienic reasons, never use the thermometer for a measurement of another part of the body after rectal use. OPERATING INSTRUCTIONS - To turn on the thermometer, press the On / Off key. The device beeps. The function symbols are displayed on the screen for a few seconds. The result of the last temperature reading is displayed for two seconds, then "36.5 ° C / 97.7 ° F", then the "° C" or "° F" icon appears in the upper right corner of the screen. The thermometer is ready for use
Take the temperature in the rectum:This method is the most reliable way to ensure that the fever does not go unnoticed. If necessary lubricate the tip of the thermometer with a little Vaseline. Place the child on your stomach on your lap or on a stable surface. Otherwise, place the child on his back with his legs bent towards his chest. Carefully insert the tip of the thermometer to a depth of approximately 1.25 cm. Never force to introduce the thermometer into the rectum. Stop in case of resistance. Hold the thermometer this way until it beeps. Remove the thermometer carefully. Read the temperature and write it down. The temperature taken at the rectum is usually half a degree Celsius or a degree Fahrenheit higher than the temperature in the mouth. By removing the thermometer,
Take the temperature in the mouth : The oral method is not recommended for children under 5 years, because they have difficulty keeping the thermometer under the tongue long enough. Place the tip of the thermometer under the tongue as far as possible. Tighten your lips gently around the thermometer. Do not bite the thermometer. Relax and breathe through the nose. Keep the thermometer under the tongue until it beeps. Wait 20 to 30 minutes after eating or drinking to take the temperature in your mouth.
Take the temperature under the armpit: The axillary method (at the armpit level) is generally used to check if a newborn or young child has fever, but it is not as accurate as the rectal method. If the axillary temperature does not reveal fever but the child is hot and seems to be suffering, take the temperature in the rectum. Wipe the armpit with a dry towel. Place the tip of the thermometer at the armpit. Make sure that the thermometer is in contact with the skin and not with the clothing. Squeeze the arm against the body to hold the thermometer in place. Keep the position until the thermometer beeps. If the temperatures displayed by two thermometers were to be compared, it is possible to obtain two different results even though the two thermometers are in their margin of precision. Thoroughly clean the thermometer before storing it. Dry it and put it in its box so that it is ready for use next time.
- When taking a measurement, the temperature displayed on the screen changes. The symbol "° C" or "° F" flashes. When the buzzer sounds 4 times, it means that the temperature has reached a stable level and that the temperature measurement is complete, the measurement is displayed on the screen for 10 minutes until the automatic shutdown of the device. Press the On / Off key to stop it manually.
- When the battery voltage is 1.25 V ± 0.06 V and the LCD displays the "" symbol, the battery needs to be replaced.
- First remove the battery cover, pull the internal part from 3 to 5 mm (not more than 10 mm), insert the new LR41 battery, with the positive over it, and check that the battery is properly clipped. Then, close the hood, restart and test.
- ° C / ° F: unit switched off, press the On / Off button for 3 seconds; it is then possible to switch between ° C and ° F.
- MEMORIZATION OF DATA: the device automatically keeps the last temperature in memory for evaluation of possible variations. When turning on the device, the last measurement is displayed after the initialization test.
Reviews
Questions
