Mercurochrome Electric rasp + 3 Refills

1. Take the roller best suited to your needs (exfoliating granules or Extra-exfoliating granules) and clip it onto the Electric Rasp. The roller must be correctly fitted before you start using the Electric Rasp.
2. Press the "ON" button to switch the appliance on. The indicator light will come on. Then select the desired speed: "I" for the slowest speed and "II" for the fastest speed.
3. Use the appliance on clean, dry Feet. Place the roller on the area of the Feet concerned and use gentle circular movements.
Note: this appliance is fitted with a safety device that stops the appliance if too much pressure is applied during use.
4. Press the "ON" button to switch the grater off. Regard if the result is satisfactory. After use, rinse Feet to remove dead Skin and dry thoroughly. Caution: do not stay on the same area for more than 3 to 4 seconds. In total, 5 to 10 minutes of use is enough for each foot. If your Skin becomes painful or a burning sensation appears, stop the appliance immediately.
5. After switching off the appliance, press the button on the left-hand side of the Electric Rasp to remove the roller. Clean the Body with a clean damp cloth, then replace the roller on the handle of the Electric Rasp.
6. Finally, apply Mercurochrome® Laboratories Hydrating Cream to your Feet, massaging gently.
7. To recharge the Electric Rasp, connect the USB cable (included) to a USB adaptor (not supplied). You can also use the adapter on a smartphone or other electrical device. The indicator light comes on and flashes when the device is charging. The light stays on when the device is fully charged.