Acorelle 300g

Heating
If you want to obtain a thick honey texture, heat the Oriental wax with Bioes strips in the microwave or in a bain-marie, in 10-second increments. In general, a few seconds of heating is enough.

Start waxing
On a perfectly clean, dry and healthy skin, start by :
1. Identify the direction of hair growth.
2. Then apply a bead of Oriental wax with Bioes strips to the top of the area to be waxed
3. Using the edge of the spatula, slide the wax in the direction of hair growth to create a thin layer. To do this, hold the spatula perpendicular to the Skin.
4. Place the cotton strip on the layer of wax you've just applied, smoothing it very firmly with the palm of your hand, all in the direction of the hair.
5. Pull the Skin taut with one hand, and with the other, remove the strip against the hair, with a sharp tug, parallel to the surface to be waxed.
6. Rinse off any wax residue remaining on your Skin with water.
7. Rinse the wax strips with water too. They can be reused up to 3 times.

Read the instructions carefully before use. Follow the instructions for use.
Before using for the first time, carry out a sensitisation test on the area to be waxed the day before waxing to check that the product is well tolerated. If no reaction is observed, depilation may proceed. Apply to clean, dry, healthy Skin. Do not use on irritated skin, wounds, scars, varicose veins, moles, damaged skin, sunburn or skin that has previously reacted to wax. Do not use within 24 hours of exposure to the Sun, or immediately after a Bath. Do not expose to the Sun for 24 hours after waxing. Avoid contact with eyes and mucous membranes. Do not swallow. Keep out of the reach of Children. It is essential to check the temperature of the wax before use, as wax that is too hot can cause burns. The amount of wax remaining after each use will decrease, so the heating time should be adjusted accordingly. Redness may appear after waxing. This will disappear within 24 hours. If the redness persists, consult a doctor. Do not use alcohol-based products on the waxed area for 24 hours after waxing. Do not overheat the wax. If it is too liquid, it will be less efficient and may cause burns. In the event of contact with eyes, rinse thoroughly with clean water. Do not use for any purpose other than that indicated.